Everything About Garage Door Openers

If you have a problem with your Genie garage door opener, it might be very easy to fix, so don’t worry. I will talk about the usual problems someone could have with a Genie garage door opener. Take them as a short but concise Genie garage door opener troubleshooting guide.

If you can’t close the garage door using the transmitter and you can close it by using the wall button, then here is what you should try. If the infrared sensors are not working well, then you should see at least one of the sensor lights flashing. In this case you should clean the eyes of the sensors if necessary, the wires should be properly connected with the sensors and the motor head and make sure that the sensor eyes are directed one to another. You could also try to reset the garage door opener, to do that you just have to unplug and re-plug the power of the opener. If it still doesn’t work, then you should replace the sensors.

When the garage door closes, after a few seconds it opens again. If this is your problem then this is what you should know. The opener has a limit for closing and opening and if the closing limit is further than where the door closes properly, then the opener will think it hit something and it will open again, it is a reaction of the safety system. After setting the limit to the right point everything should work just fine.

To program the transmitter from your car for a Genie Intellicode or Chamberlain security plus system, here is what you should do. The first thing you must do is to clear everything that is on the car transmitter (reset it). After doing that you should decide what button you want to use as a transmitter. After deciding, push the remote button and the in-car transmitter buttons at the same time, when doing this hold the remote close to the button. The last thing you need to do is to press the learn button on your Genie garage door opener, you should see a light flashing rapidly after you press it, and then use the button from your car until the garage door works.

If you want to program the Intellicode or Security Plus transmitter, this is what you can do. To remove the transmitter that is programmed on your garage door opener you just have to hold the Learn or the Smart button until the light stops flashing. If you want to program a transmitter to your opener you just have to push the Learn or the Smart button. You will see a light flashing rapidly. Now use the transmitter which you desire to use close to the receiver until the garage door opens or closes.

Another issue which can occur is that your garage door opens and closes just like that. In most cases the problem is that there is a short in your transmitter or wall button. In this case you should remove the batteries from your transmitter and leave it so for a few days, if the garage door doesn’t open anymore, then you know where the problem is. If you still have the problem even after a few days, then you should check the wires from the wall button. To be sure you could also replace the wires.

If you can’t find the Learn button, then you should know that it is placed under the light lens cover, very close to the Floppy Antenna wire.

I hope this article has helped you solve your Genie garage door opener issues. I talked about the most common problems, which occur with this type of opener. If you haven’t solved your problem or if you can’t find it here you can always ask a professional.